Common Technical Terms For Printers(1)

Mar 11, 2019

Leave a message

1. Pica: 10 characters per inch, also known as 10CPI.

2. Elite: Prints 12 characters per inch, also known as 12CPI.

3. Draft: This is a way to print a character with fewer dots to increase the printing speed.

4. Letter Quality: This is a way to print a character with more dots to improve the quality of the print, but the print speed is slower.

5. Proportional: The space of each printed character is proportional to the width of the character, for example, the narrowest character I and the widest character M, and the narrow character I takes up less space than the wide character M. This prints a more beautiful character.

6. Condensed: The printed characters are 60% of the normal character width.

7. Emphasized: In order to get the enhanced character printing effect, the printing is repeated twice per point, and the second time is played on the right side of the first time to get the purpose of deepening the character color.

8. Double-strike: After the print head prints the first point, the paper will be fed 1/180 inch forward, and then the second point will be printed, that is, each character is also printed twice, the second time. Printed slightly below the last point, this method of printing is to fill the gap between the dots to make the printed characters appear clearer. 9. Double-Width: Doubles the width of the printed characters.

10. Italic: The printed font is italic.

11. Underline: Prints a continuous bottom line under the printed characters.

12. CPI: Word density unit, indicating the number of characters printed per inch.

13.CPS: The number of characters that can be printed per second.

14.CPM: The number of characters that can be printed per minute.

15.PPM: The number of pages that can be printed per minute.

16. CPL: The number of characters that can be printed per line.

17. DPMM: Point density unit, which indicates the number of dots that can be printed per millimeter.

18. DPI: Point density unit, which indicates the number of dots that can be printed per inch.

19. Word spacing: the center distance between two adjacent characters.

20. Line spacing: The center distance between two adjacent lines.

Send Inquiry