Stylus Printer Ribbon

May 25, 2019

Leave a message

To judge the pros and cons of a ribbon, first look at its base. The belt base should not have wrinkles, blemishes, breaks or mildew. The 9-pin printer's ribbon tape base can be used with a nylon tape of normal density, while the 24-pin printer must use a high-density nylon tape. A simple method for judging whether the tape base is ordinary density or high density is to observe the nylon tape under the lamp, the light transmission is a normal density zone, and the opacity is a high density zone. However, some imported (such as the United States) high-density belts are light-transmissive, while some ordinary density belts are opaque, and must be measured by special instruments.

High-quality ribbons generally use nylon 66 as the base material, while some lower-quality ribbons use nylon 6. The main difference between the performance of nylon 66 and nylon 6 is that the former has a maximum heat resistance temperature of 130 ° C, while the latter has only 90 ° C. Working at a high temperature printhead, the performance of nylon 66 is definitely better than nylon 6. At the same time, the elastic recovery rate of nylon 6 is poor, and the longer the belt is, the more the ribbon is forced to die.

Second, we must distinguish the quality of the ink. High-quality ink is made up of various ingredients such as binder, surfactant, thickener, smoothing agent, ultraviolet absorber, dye, pigment, etc., and it can smell a special ink smell. The inferior color has a part of the domestic printer ink instead of the special printer ink, which smells like diesel. The oxidation resistance of high-quality ink is higher than that of inferior quality, which can keep the imprint for a long time without fading or discoloration, and can extend the printing life by 100,000 characters and about 30,000 Chinese characters.

The high-quality ribbon is uniform in ink, the color is calm, and the ink content is stable; the inferior ribbon tends to have a certain luster due to the ink ubiquitous on the surface, and the solid particles in the ink are too thick to accelerate the wear of the printing needle, shortening the printing. The life of the needle, or the print head due to its loss of control.

Third, the third key factor affecting the quality of the ribbon is the soldering method of the interface. At present, the advanced method is to ultrasonically weld the belt-based interface, the thickness is not more than 0.2mm, the interface is flat, no loose wire, the welding angle is reasonable, and the weld seam is fine. Inferior ribbons are usually butt welded with electric soldering irons and electric heating wires. The width of the misalignment is large. In order to improve the welding strength, the method of reducing the interface angle and lengthening the length of the nozzle is adopted, which causes great wear on the printing needle.

Finally, the control of the ink content during the dyeing of the ribbon and the mechanical properties of the components of the ribbon frame and the perfect fit are also the criteria for judging the quality.

Send Inquiry